Since I haven't blogged for some time and I'm only getting back to working with the Intel Galileo again, I've decided to write up a quick tutorial to make up for lost time. In this tutorial I'll address a key drawback to the Intel Galileo and a handy solution to remedy.

Since I've recently succeeded in getting my Galileo online, I've wasted no time in pressing it to its full potential as an IoT board. In this tutorial I'm recasting the Galileo as a Twitter-Bot to post my tweets to the world!

As a continuation on since my last post, I wanted to take things a little further and enable WiFi sharing on my Mac over ethernet. In turn, allowing my Galileo to access the internet. Do it yourself in just five steps.

Since I've decided to migrate over to Eclipse in order to program my Galileo, I've needed a persistent IP address in order to make a target connection. Since I couldn't find much in the way of instructions online, I decided on writing my own tutorial to guide others through the process, step by step.

While most components you'll likely use with Arduino are relatively cheap, sometimes there's the odd part that comes at a premium that's outside your budget. Here's my experience with the alternative.

A few days back I had my first look at the Intel Galileo. Since then, I've had time to cast my eye over another remarkable IoT board - the Arduino Yún.

Yesterday, I finally had the chance to set up my new Intel Galileo (Gen 2). Not an easy task as I found out!